Partition your Design for FPGA Prototyping

Modern ASIC and SoC designs have increased in complexity such that multiple FPGAs of the largest capacity are now required to prototype the entire functionality of the design. As design sizes increase, more and more FPGAs are required. The capacity and pin limitations of FPGAs create constraints for how the ASIC/SoC design can be mapped into the FPGAs. Aldec’s HES-DVM’s prototyping mode accounts for the limitations of the target FPGAs and allows the user to map a design to the FPGAs within these constraints.

Partitioning a design to fit into multiple FPGAs can be a lot of work

Designing the partitions with HES-DVM is as easy as selecting specific VHDL/SystemVerilog design modules from the hierarchy and moving them to a desired partition. All information about the design modules and the amount of LUTs, Flip-flops, memory blocks, DSP slices, and I/O consumed are displayed for convenience. These values can also be viewed as a percentage of the target FPGAs’ available resources allowing you to know when an FPGA is full.

Adding a module to a partition

Mapping a partition to an FPGA

Once the partitions are finalized, each partition can be assigned to a specific FPGA. A design successfully fitting into the FPGAs on the target prototyping board is only the beginning. There still remains a big problem with the sheer number of connections between the partitions. Modern designs have thousands of internal signals interconnecting major blocks or sub-systems. It’s likely that there won’t be a sufficient amount of direct connections between FPGAs to support the design’s internal wiring. How can the large amount of internal design signals possibly be accommodated by the relatively smaller amount of I/O available from the FPGAs?

For the rest of this article, visit the Aldec Design and Verification Blog.

Tags: asic, FPGA, HES-7, HES-DVM, prototyping, SoC, SoC and ASIC Prototyping

This entry was posted on Monday, December 11th, 2017 at 9:29 am. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.