>> Mentor PCB Product Discussion
Thread views: 4829 View all threadsNext thread*Threaded Mode

(Stranger )
10/28/13 01:40 AM
Tips For Designing RF And Microwave PCB Report this article as Inappropriate to us !!!Login to Reply

A few decades ago, there wasn’t much demand for RF and microwave pcb board circuits. They were difficult to design into the architectures of the time, and so costly that only mil/aero projects could afford them. But today RF circuitry is crammed into a large variety of commercial products. pcb board Most of these are handheld wireless devices for medical, industrial, and communications applications, plus applications in a variety of fields are migrating from desktop models to become portable communications units. Not only is RF becoming more ubiquitous, pcb board but microwave circuitry as well, both capturing very high frequencies (VHF) and ultra-high frequencies (UHF).
Printed circuit boards (PCBs) pcb board now encompass much more than pure digital or mixed-signal technologies, and the PCB layout designer faces many more challenges when designing sub-assemblies with high frequency RF and microwave.
The RF frequency range is typically from 500 MHz to 2 GHz, and designs above 100 MHz are considered RF. The microwave frequency range is anything above 2 GHz. There’s a considerable difference between RF and microwave circuits versus typical digital and analog circuits. In essence, RF signals are very high frequency analog signals. Therefore, unlike digital, at any point in time an RF signal can be at any voltage and current level between minimum and maximum limits pcb board.
Standard analog signals are assumed to be between DC and a few hundred megahertz. pcb board But RF and microwave signals are one frequency or a band of frequencies on a very high frequency carrier (Figure 1). Unlike digital signals associated with one voltage or one current, RF and microwave signals operate on a frequency pcb board. RF and microwave circuits are designed to pass signals within a certain band. pcb board They use band pass filters to transmit signals in a so-called band of interest. pcb board The signal within a range of frequency passes through this band range pcb board, and the rest of the frequencies of the signal are filtered. A single band can be very narrow or very wide and carried upon a very high frequency carrier wave.

(Stranger )
12/17/17 11:44 PM
Re: Tips For Designing RF And Microwave PCB new [re: hqew2013]Report this article as Inappropriate to us !!!Login to Reply

According to the case study writing service, the RF frequency range is usually 300 MHz to 2 GHz. What are the main features of the waves though? I can't find the info in the case study mentioned in the samples section.

(Stranger )
01/16/18 11:04 PM
Re: Tips For Designing RF And Microwave PCB new [re: stevenlanders]Report this article as Inappropriate to us !!!Login to Reply

  You have posted a extremely detail document. I go through all of your article and I actually really like it, I understand your point of view. gmail sign in

View all threadsNext thread*Threaded Mode
Jump to


Internet Business Systems © 2018 Internet Business Systems, Inc.
25 North 14th Steet, Suite 710, San Jose, CA 95112
+1 (408) 882-6554 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering TechJobsCafe - Technical Jobs and Resumes GISCafe - Geographical Information Services  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy PolicyAdvertise