Most discussions on shielding for EMC address the
shielding of enclosures and give rules of thumb regarding the size
of slots and holes. These recommendations are not applicable in
general to the design of shielded cable assemblies. Because there
exists a gap in published information on the unique shielding
requirements for cable assemblies, this document was generated.
The scope of this document is that it will apply to low cost
shielded multiconductor cable assemblies. While some of this
information will be applicable to coaxial RF cable assemblies, this
is not the main focus of this document.
|
Editorial
Upcoming Events
DAC 2012 at San Francisco CA - Jun 3 - 7, 2012
|
|
|
