Bit-Slice Design: Controllers and ALUs

by Donnamaie E. White

Copyright © 1996, 2001, 2002 Donnamaie E. White



Table of Contents

1. Introduction

2. Simple Controllers

3. Adding Programming Support to the Controller

4. Refining the CCU

5. Evolution of the ALU

6. The ALU and Basic Arithmetic

7. Tying the System Together




Refining the CCU

Last Edit November 2, 1996; May 1, 1999; July 7, 2001

In a microcomputer system there is a need to interface the main or central unit (microprocessor and/or control unit) to one or more external devices such as sensors, displays, control panels, keyboards or external memory. The main objective is to design the interface to minimize the effect of the interface activities on the system throughput or performance. Any contact with any external device will be considered as input/output handling or I/O.

Although there are many schemes for handling I/O requests, interrupts and queuing will be covered very lightly herein, principally as a means of alerting the designer to the existence of the problems. (The subject warrants its own seminar.) Only those schemes relevant to firmware design will be explored in any detail.

There are two very basic methods of I/O handling - status polling and interrupt servicing.

Status Polling

With status polling, the controlling unit must interrogate each peripheral to determine if it needs servicing by testing the status line of each peripheral, one at a time.

This might be by the elementary "Round Robin" approach, where the devices are tested in a set, circular sequence. Where different devices are to be handled on a priority basis, priority is accomplished by assigning high-priority devices to more than one location in the testing sequence. A high-priority device is tested with a higher polling frequency than the low-priority items.

Figure 4-1 Status polling microprogram flowchart


  • One problem with status polling is that a device requesting service must wait for its turn even if all other devices are inactive.
  • The controlling unit, a processor or a controller, must waste time testing inactive status lines; this reduces the possible system throughput.
  • With the sequence test under microprogram control, a long microroutine is necessary, since each status test requires its own microinstruction.
  • In terms of the requesting device, the system response is relatively slow.

When to Use or Not Use

The scheme is suitable if the frequency of service requests for each device is known with some degree of accuracy. This allows the polling frequency to be custom-tailored to the system. The service time, once a request for service is acknowledged, should be long compared to the estimated wait time.

It is not an advisable scheme where interfacing to a human is involved; that is, requests should be primarily I/O to hardware devices. (Human patience tends to decrease with exposure to computers; and has dropped from minutes (way back) to 30 sec (60's) to 1-3 sec. Look at the operating speeds of 1980's PCs (200-250MHz) compared to 16MHz systems, and the forecasted 500MHz systems (1998-9). Even children's game systems are at 64-bit computing speeds and climbing and these children will demand even faster response.

Or, watch someone trying to access the Internet during internet traffic jams. Humans want instant gratification. The normal phone connection came and went in and out of vogue in less than three years because it is not fast enough to keep up with the increasingly more demanding computer user.

For information about this file or to report problems in its use email

Copyright © September 1996, 1999, 2001, 2002 Donnamaie E. White White Enterprises

S2C: FPGA Base prototyping- Download white paper

Internet Business Systems © 2016 Internet Business Systems, Inc.
595 Millich Dr., Suite 216, Campbell, CA 95008
+1 (408)-337-6870 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering TechJobsCafe - Technical Jobs and Resumes GISCafe - Geographical Information Services  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy Policy