Logic Design for Array-Based Circuits
Copyright © 1996, 2001, 2002 Donnamaie E. White
Sizing the Design - Selecting the Array
Last Edit July 22, 2001
Architectural Specification or Hardware Specification
Once a clear definition exists of the circuit or circuits that will be placed on one array, then the planned design can be developed. This is on a smaller module scale than the block-level functional specification, e.g., at the level of counters, adders, latches, registers, sequencers, etc. The performance requirements defined in the functional specification can be used to select the technology.
Table 3-5 Array-Specific Specifications
The review of available arrays is conducted in parallel with the creation of the hardware specification.
With the descriptions developed for the modules, equivalent gate estimates can be made for the circuit, or estimated cell usages can be computed for the circuit on a specific array. The array vendor Applications Engineer can help with the sizing esti mate.
The hardware design specification details what the designer intends to do to meet the target functional specification. This level of specification can be equated to a PDL (program definition language) description of software and is the basis for the evolution of HDL, hardware description language, and its derivatives.
If a particular testing methodology is being enforced, the sizing estimates must take this additional logic into account. If additional testing logic, such a parametric gate tree or parity logic, is to be used, it must be included in the sizing estimates.
The specification may include proposed vendors and arrays.
Table 3-6 Components of The Hardware Specification
There should be a design review of the architectural or hardware specification before final selection of an array series. On final selection, the specification should be revised to show that series and all computations performed for that series.
Note that a workstation can provide some assistance. The critical path may be captured in more than one version and comparisons made based on an annotated simulation.
Power and sizing details can be run against a macro list rather than a full interconnect netlist. (This tool is vendor-dependent.) Check if such a pre-capture tool is available to help size the circuit.